|
Brush
seals, weather seals, energy saving dock leveler seal, door seals. Brush
seal, weatherstripping, rolling steel doors, sectional overhead
doors |
|
|
Brush
Seals and Weather Seals Door
Installation
Sides and Top
STOP! -
BEFORE CUTTING PLEASE READ -
CLICK HERE
Step 1:
Start by measuring top for full width strip. Cut to length and
put strip in place; pressing against closed door enough to
bend brush as needed. Mark a line at this point or punch in
end screw holes.
(you may omit step 4 in cutting instructions, as brush cannot slide
out in this position) |
 |
| Top corners should be
notched to create a good joint: at top of side strip, make a
35° cut ½" down and another vertical cut to remove piece as
shown - use a piece of strip to mark 35° angle. |
 |
Step 2:
Tighten all screws in place.
|
 |
Step 3:
On hinge side, measure and cut to butt up against top piece
and flush to bottom.
NOTE: on this side, the brush must be set carefully, so
that it is not pinched behind the door back as it closes.
Fasten lightly in place and move in or out until the door closes
with a proper seal without pulling brush into the crack.
Step 4:
Making sure it doesn't pinch, screw strip in final position.
|
Step 5:
The latch-side seal requires only to measure, cut and fasten in
place in the manner by which you have now become an expert. |
 |
Brush Seals Door Installation
Bottom Sweep
Installing Dock
Leveler Seals
|
|
