|
Memtech Brush Seals and
Weather Seals Door
Installation
BOTTOM SWEEP
STOP! -
BEFORE CUTTING PLEASE READ -
CLICK HERE
Step 1:
The "sweep", is the flat brush seal which mounts to door
bottom on side toward which door opens... so it "sweeps" in
closing.
Place the
strip along door bottom to find its width and mark for cutting. Cut to
maximum outside width, so that brush will extend into bottom corners, but
not wider than door (it could cause a snag).
Step 2:
Cut Brushield strip according to the illustration. This procedure
applies to all cuts of this product mentioned herein; never cut brush and
extrusion together, as sawed (uncrimped) brush will lose its
filaments.
Step 3:
Place strip at door bottom and test for proper position: The brush should
bend slightly at door's closed position to gain a seal. Mark screw
holes with a nail or punch, at center of slots.
| In setting height, check
pressure on brush when door swings fully open; a rise in the floor
could cause the door to stick or crush the brush if left open.
Place screws snugly but not tightly about center-way in their slots
and find a compromise level to fasten them permanently.
Tighten at that point. |
 |
Brush Seals Door Installation Sides and Top
Installing Dock
Leveler Seals
|
